Advanced Firmware update

Firmware and bootloader update via USB

Sometimes it’s necessary to update not only the firmware, but also the bootloader. In this case you will need .dfu image of the firmware. Download .dfu firmware file and set BOOT switch on SmartAP board to UPD mode. It will allow SmartAP running in USB firmware update mode. Connect the board to your computer with USB cable and run DfuSe utility. Press “Choose” in “Upgrade of Verify” section and select the .dfu file you would like to load. Then press “Upgrade”.

Image

Image

Wait 40-60 seconds until you get the message that the firmware was successfully updated.

Do not forget to put the switch back to RUN position.