Initial Power Up

Powering up SmartAP AIRLink for the first time after wiring the peripherals

Make sure you have completed all Installation steps and connected antennas before proceeding with the power up.

You will see that various LEDs will turn on and some of them will start blinking. This means that the AIRLink is live and booting up. In particular, make sure that the PWR green LED is solid. This means that the AIRLink is powered up and running properly.

PWR green LED is solid meaning that the unit is powered up properly

Check available WiFi networks on your computer or tablet and connect to AIRLink network to set up the initial WiFi connection of the AIRLink.

The name of the network is unique for each AIRLink and starts with AirLinkConfig_ and ends with a collection of unrelated symbols.

Default password: airlink1

3. Open web browser

Once you're connected to the AIRLink network, open the web browser and proceed with the initial configuration.

Go to: 10.42.0.1

This is the default IP address of the AIRLink. You will see the following welcome page:

This page displays the generic information about the system including its status, system ID and current software version. You can see the current WiFi network status by clicking Show WiFi Status:

By default, AIRLink is configured as the access point. If you would like to connect AIRLink to your home or office WiFi network then click the Connect to WiFi network button.

4. Connect to WiFi

You will see the discovered WiFi networks list:

Select the network you would like to connect to and click on its name. You will be asked to enter the WiFi network password:

After you have typed the password please click Connect.

After pressing the button, AIRLink will attempt to connect. This may take a few minutes. AirLinkConfig network will be disabled and most likely your computer will connect to the other known network. However, if you entered the wrong password or the access point rejects the connection for other reasons, turn on the AirLinkConfig access point again. Your computer is unlikely to automatically connect to it and you may have to do this manually.

After pressing the button, the device will be expected to appear at the address airlink.local, if it is supported by your router / computer, and will automatically redirect there. If your router does not support the Local DNS option, then you can find the assigned address on the settings page of your router and access AIRLink with the IP address (this is usually 192.168.1.X).

In our case we found our that the IP address of the AIRLink in the home / office network is 192.168.1.157

Therefore, if we go to 192.168.1.157 in the web browser we will see the same welcome page.

CONGRATULATIONS! Now your AIRLink is connected to Internet.

By default, your AIRLink is owned by the manufacturer (Sky-Drones) or other licensed manufacturer. You can claim ownership of the AIRLink and assign it to your account.

AIRLink ownership is required to use Sky-Drones Cloud services. Therefore, we highly recommend to claim your AIRLink ownership at this step. Make sure you have the following:

  • Sky-Drones Cloud account. If not - create here.

  • AIRLink is connected to WiFi and has internet access.

Go to the main configuration page of AIRLink using IP address discovered in the steps above. In Ownership Transfer section click Claim Ownership:

Enter your Sky-Drones Cloud email and password to authenticate. Click Authenticate:

If the authentication was successful you will see the following message confirming that your identity was successfully verified.

If you have any troubles at this step - make sure you have your Sky-Drones Cloud and your email and password are correct.

Click Claim Ownership of this AIRLink. If successful – you should see the following confirmation message:

CONGRATULATIONS! Your AIRLink has been successfully set up and now you can proceed to its configuration for your vehicle. We recommend to use SmartAP GCS for the initial vehicle configuration setup. Later you can use Sky-Drones Cloud web services for real time flight monitoring and control. Your AIRLink is already available in your Sky-Drones Cloud account.